ISO3082DWR Datasheet PDF - TI

●DESCRIPTION

●The ISO3080, and ISO3086 are isolated full-duplex differential line drivers and receivers while the ISO3082, and ISO3088 are isolated half-duplex differential line transceivers for TIA/EIA 485/422 applications.

●These devices are ideal for long transmission lines since the ground loop is broken to allow for a much larger common-mode voltage range. The symmetrical isolation barrier of the device is tested to provide 2500 Vrms of isolation for 60s between the bus-line transceiver and the logic-level interface.

●Any cabled I/O can be subjected to electrical noise transients from various sources. These noise transients can cause damage to the transceiver and/or near-by sensitive circuitry if they are of sufficient magnitude and duration. These isolated devices can significantly increase protection and reduce the risk of damage to expensive control circuits.

●The ISO3080, SO3082, ISO3086 and ISO3088 are qualified for use from –40°C to 85°C.

●FEATURES

●• 4000-VPEAK Isolation

●• Bus-Pin ESD Protection

●– 16 kV HBM Between Bus Pins and GND2

●– 6 kV HBM Between Bus Pins and GND1

●• 1/8 Unit Load – Up to 256 Nodes on a Bus

●• Meets or Exceeds TIA/EIA RS-485 Requirements

●• Signaling Rates up to 20 Mbps

●• Thermal Shutdown Protection

●• Low Bus Capacitance – 16 pF (Typ)

●• 50 kV/µs Typical Transient Immunity

●• Fail-safe Receiver for Bus Open, Short, Idle

●• 3.3-V Inputs are 5-V Tolerant

●APPLICATIONS

●• Security Systems

●• Chemical Production

●• Factory Automation

●• Motor/Motion Control

●• HVAC and Building Automation Networks

●• Networked Security Stations