UCC28180D Datasheet PDF - TI

●The UCC28180D is a 8-pin active Power-Factor Correction (PFC) Controller operates under continuous conduction mode (CCM) to achieve high power factor, low current distortion and excellent voltage regulation of boost pre-regulators in AC to DC front-ends. The controller is suitable for universal AC input systems operating in 100W to few-kW range with the switching frequency programmable between 18 to 250kHz, to conveniently support both power MOSFET and IGBT switches. An integrated 1.5 and 2A (SRC-SNK) peak gate drive output, clamped internally at 15.2V (typical), enables fast turn-on, turn-off and easy management of the external power switch without the need for buffer circuits. Low-distortion wave shaping of the input current using average current-mode control is achieved without input line sensing, reducing the external component count.

● Trimmed current loop circuits for low iTHD

● Reduced current sense threshold

● Average current-mode control

● Soft over current and cycle-by-cycle peak current limit protection

● Output overvoltage protection with hysteresis recovery

● Audible noise minimization circuitry Open loop detection

● Enhance dynamic response during output overvoltage and undervoltage conditions

● Burst mode for no load regulation

● Green product and no Sb/Br

●Device has limited built-in ESD protection, leads should be shorted together or the device placed in conductive foam during storage or handling to prevent electrostatic damage to the MOS gates.