DRV8432EVM Datasheet PDF - TI

●The DRV8432EVM is an evaluation board for DRV8432, a dual full bridge PWM motor driver with an advanced protection system. It has a maximum recommended supply voltage of 52V and is capable of delivering 2x7A continuous output current and 2x12A peak current per device. The DRV8432 has an advanced protection system consisting of short circuit protection, over current protection, under voltage protection, and two stage thermal protection. The evaluation board can be operated with either two full bridge outputs or 4 half bridge outputs. It can also be used in parallel mode to double the current capability. The unit can be operated with external PWM inputs using a MCU controller module or signal generator, etc. The outputs and power supplies can be connected using stripped wires by connecting them to the on board terminal blocks. The EVM module also has hardware switches to control the modes and to allow a manual reset.

● 2 x 12A peak / 2 x 7A RMS current output

● 1 x 24A peak / 1 x 14A RMS current output

● 0V to 52V (12V gate drive) wide operating voltage

● PWM control interface

● Two stage thermal and short circuit protection

● On board header/test points for external control of the DRV8432

● Double side, plated through PCB layout

● Self contained protection system (short circuit and thermal)