●The DRV8809/DRV8810 provides an integrated motor driver solution. The chip has four H-bridges internally and is configurable to eight different modes of combination motor driver control.
●The output driver block for each H-bridge consists of N-channel power MOSFETs configured as full H-bridges to drive the motor windings. The stepper motor control has a 16-step mode programmable through the 3-wire serial interface (SPI). The SPI input pins are 3.3-V compatible and 5-V tolerant.
●The DRV8809/DRV8810 has three DC-DC switch-mode buck converters to generate a programmable output voltage from 1.5 V to 80% of VDIN (channel A) or up to 10 V (for channel B and channel C), with up to 1.5-A load current capability. The outputs are selected using the C_SELECT terminal at start-up or using serial interface during operation.
●An internal shutdown function is provided for overcurrent protection (OCP), short-circuit protection, overvoltage/undervoltage lockout (UVLO), and thermal shutdown (TSD). Also, the device has a reset function that operates at power on and at input to the In-Reset pin.
● Configurable to Eight Modes of Combination Motor Driver
● Bipolar Stepper Motor Driver
● 16-Step Current-Mode Control
● 800-mA Average Output Current as Stepper
●Motor Drive
● DC Motor Driver
● 800-mA Maximum Continuous Current and
●8-A/500-ns or 3-A/100-ms Peak Current for
●Each DC Motor Drive
● Low ON resistance Rds(ON) = 0.55 Ω at TJ = 25°C (Typ)
● Three Integrated DC-DC Converters
● On/Off Selectable Using C_SELECT Pin and Serial
●Interface
● Outputs Programmable With External Resistor Network
●From 1.5 V to VDIN × 0.8
● 1.5-A Output Capability for All Three Channels
● 7-V to 40-V Operating Voltage Range for DC-DC Converters
● Two Serial Interfaces for Communications
● Thermally Enhanced Surface-Mount 64-Pin QFP PowerPAD™
●Package (Eco-Friendly RoHS and No Sb/Br)
● Power-Down Function (Deep-Sleep Mode)
● Reset Signal Output (Active Low)
● Reset (All Clear) Control Input
Part 3D Model
