●56F801 16-bit Hybrid Controller
●• Up to 30 MIPS operation at 60MHz core frequency
●• Up to 40 MIPS operation at 80MHz core frequency
●• DSP and MCU functionality in a unified, C-efficient architecture
●• MCU-friendly instruction set supports both DSP and controller functions: MAC, bit manipulation unit, 14 addressing modes
●• Hardware DO and REP loops
●• 6-channel PWM Module
●• Two 4-channel, 12-bit ADCs
●• Serial Communications Interface (SCI)
●•8K ×16-bit words Program Flash
●•1K ×16-bit words Program RAM
●•2K ×16-bit words Data Flash
●•1K ×16-bit words Data RAM
●•2K ×16-bit words Boot Flash
●• Serial Peripheral Interface (SPI)
●• General Purpose Quad Timer
●•JTAG/OnCETM port for debugging
●• On-chip relaxation oscillator
●•11 shared GPIO
●• 48-pin LQFP Package
●56F801 Features
●Digital Signal Processing Core
●• Efficient 16-bit 56800 family hybrid controller engine with dual Harvard architecture
●• As many as 40 Million Instructions Per Second (MIPS) at 80MHz core frequency
●• Single-cycle 16 ×16-bit parallel Multiplier-Accumulator (MAC)
●• Two 36-bit accumulators including extension bits
●• 16-bit bidirectional barrel shifter
●• Parallel instruction set with unique DSP addressing modes
●• Hardware DO and REP loops
●• Three internal address buses and one external address bus
●• Four internal data buses and one external data bus
●• Instruction set supports both DSP and controller functions
●• Controller style addressing modes and instructions for compact code
●• Efficient C compiler and local variable support
●• Software subroutine and interrupt stack with depth limited only by memory
●• JTAG/OnCE debug programming interface
●Memory
●• Harvard architecture permits as many as three simultaneous accesses to Program and Data memory
●• On-chip memory including a low-cost, high-volume Flash solution
●—8K ×16 bit words of Program Flash
●—1K ×16-bit words of Program RAM
●—2K ×16-bit words of Data Flash
●—1K ×16-bit words of Data RAM
●—2K ×16-bit words of Boot Flash
●• Programmable Boot Flash supports customized boot code and field upgrades of stored code through a variety of interfaces (JTAG, SPI)
●Peripheral Circuits for 56F801
●• Pulse Width Modulator (PWM) with six PWM outputs, two Fault inputs, fault-tolerant design with deadtime insertion; supports both center- and edge-aligned modes
●• Two 12-bit, Analog-to-Digital Converters (ADCs), which support two simultaneous conversions with two 4-multiplexed inputs; ADC and PWM modules can be synchronized
●• General Purpose Quad Timer: Timer D with three pins (or three additional GPIO lines)
●• Serial Communication Interface (SCI) with two pins (or two additional GPIO lines)
●• Serial Peripheral Interface (SPI) with configurable four-pin port (or four additional GPIO lines)
