●The ESP M1 series combined type 1, 2 and 3 Tested Surge Protector for use on mains power distribution systems primarily to protect connected electronic equipment from transient overvoltage on the mains supply. It is use at boundaries up to LPZ 0A to protect against flashover through to LPZ 3 to protect sensitive electronic equipment. The remote display means the protector can be mounted close to the incoming feed or first way on the distribution board and the display in an easily visible position. The full mode design is capable of handling partial lightning currents as well as allowing continual operation of protected equipment. Innovative multiple thermal disconnect technology for safe disconnection from abnormal or faulty supplies. Remote indication facility allows pre-failure warning to be linked to a building management system, buzzer or light.
● Very low let-through voltage between all sets of conductors
● Repeated protection in lightning intense environments
● Remote display gives three way visual indication of protection status
● Plug-in cable connections between protector and display enable easy connection
● Advanced pre-failure warning so you need never be unprotected
● Changeover active volt-free contact enables the protector to be used to warn of phase loss
● Unique flashing warning of potentially fatal neutral to earth supply faults
● Robust steel housing (protector) and sturdy ABS housing (display)
● Base provides ultra-low inductance earth bond to metal panels
● Remote display comes with integral fixings and a panel drilling template
