LP3947ISD-51/NOPB Datasheet PDF - TI

●The LP3947ISD-51/NOPB is a complete Charge Management System that safely charges and maintains a Li-ion battery from either USB power source or AC adaptor. In USB mode, the LP3947 supports charging in low power or high power mode. Alternatively, the LP3947 can take charge from AC adaptor. In both USB and AC adaptor modes, charge current, battery regulation voltage and End of Charge (EOC) point can be selected via I2C interface. It can also operate on default values that are pre-programmed in the factory. The battery temperature is monitored continuously at the Ts pin to safeguard against hazardous charging conditions. The charger also has under-voltage and over-voltage protection as well as an internal 5.6 hour timer to protect the battery. The pass transistor and charge current sensing resistor are all integrated inside the LP3947. The LP3947 operates in four modes: pre-qualification, constant current, constant voltage and maintenance modes.

● Supports USB charging scheme

● Integrated pass transistor

● Near-depleted battery preconditioning

● Monitors battery temperature

● Under voltage and over voltage lockout

● Charge status indicators

● Charge current monitor analog output

● LDO mode operation can source 1A

● Continuous over current/temperature protection

● Green product and no Sb/Br

●Device has limited built-in ESD protection, leads should be shorted together or the device placed in conductive foam during storage or handling to prevent electrostatic damage to the MOS gates.