●Overview
●The LPC1102/1104 are an ARM Cortex-M0 based, low-cost 32-bit MCU, designed for 8/16-bit microcontroller applications, offering performance, low power, simple instruction set and memory addressing together with reduced code size compared to existing 8/16-bit architectures.
●The LPC1102/1104 operate at CPU frequencies of up to 50 MHz.
●The peripheral complement of the LPC1102/1104 includes 32 kB of flash memory, 8 kB of data memory, one RS-485/EIA-485 UART, one SPI interface with SSP features, four general purpose counter/timers, a 10-bit ADC, and 11 general purpose I/O pins.
●Remark:
● The LPC1104 has a revised pinout and contains several features not found in the LPC1102:
● Two extra GPIO pins (PIO0_1 and PIO0_6).
● Extra match output (CT32B0_MAT2).
● CLKOUT feature.
● Easier re-entry to ISP via PIO0_1.
● SSP0_CLK available on two pins (A1 and A2) to support debugging of SSP communication.
● Better positioning of the XTALIN pin for easier PCB layout.
●MoreLess
●## Features
●### System
● ARM Cortex-M0 processor, running at frequencies of up to 50 MHz
● ARM Cortex-M0 built-in Nested Vectored Interrupt Controller (NVIC)
● Serial Wire Debug
● System tick timer
●### Memory
● 32 kB on-chip flash programming memory
● 8 kB SRAM
● In-Application Programming (IAP) and In-System Programming (ISP) support via on-chip bootloader software
●### Digital peripherals
● 11 General Purpose I/O (GPIO) pins with configurable pull-up/pull-down resistors and programmable open-drain mode
● GPIO pins can be used as edge and level sensitive interrupt sources
● Four general purpose counter/timers with a total of one capture input and 10 match outputs
● Programmable windowed WatchDog Timer (WDT)
●### Analog peripherals
● 10-bit ADC with input multiplexing among five pins
●### Serial interfaces
● UART with fractional baud rate generation, internal FIFO, and RS-485 support
● One SPI controller with SSP features and with FIFO and multi-protocol capabilities
●### Clock generation
● 12 MHz internal RC oscillator trimmed to 1 % accuracy that can optionally be used as a system clock
● Programmable watchdog oscillator with a frequency range of 9.4 kHz to 2.3 MHz
● PLL allows CPU operation up to the maximum CPU rate without the need for a high-frequency crystal. May be run from an external clock or the internal RC oscillator
● Clock output function with divider that can reflect the system oscillator clock, IRC clock, CPU clock, and the Watchdog clock (LPC1104 only)
●### Power control
● Integrated PMU (Power Management Unit) to minimize power consumption during Sleep and Deep-sleep modes
● Power profiles residing in boot ROM allowing to optimize performance and minimize power consumption for any given application through one simple function call
● Two reduced power modes: Sleep and Deep-sleep modes
● Processor wake-up from Deep-sleep mode via a dedicated start logic using up to six of the functional pins
● Power-On Reset (POR)
● Brownout detects with three separate thresholds for interrupt and forced reset
●### Additional Features
● Unique device serial number for identification
● Single 3.3 V power supply (1.8 V to 3.6 V)
● Available as WLCSP16 package
Part 3D Model
