● Low Supply Voltage Range: 3.6 V Down to 1.8 V
● Ultra-Low Power Consumption
● Active Mode (AM): All System Clocks Active 265 µA/MHz at 8 MHz, 3.0 V, Flash Program Execution (Typical) 140 µA/MHz at 8 MHz, 3.0 V, RAM Program Execution (Typical)
● Standby Mode (LPM3): Real-Time Clock With Crystal, Watchdog, and Supply Supervisor Operational, Full RAM Retention, Fast Wake-Up: 1.7 µA at 2.2 V, 2.5 µA at 3.0 V (Typical)
● Off Mode (LPM4): Full RAM Retention, Supply Supervisor Operational, Fast Wake-Up: 1.6 µA at 3.0 V (Typical)
● Shutdown RTC Mode (LPM3.5): Shutdown Mode, Active Real-Time Clock (RTC) With Crystal: 1.24 µA at 3.0 V (Typical)
● Shutdown Mode (LPM4.5): 0.78 µA at 3.0 V (Typical)
● Wake-Up From Standby Mode in 3 µs (Typical)
● 16-Bit RISC Architecture, Extended Memory, up to 25-MHz System Clock
● Flexible Power Management System
● Fully Integrated LDO With Programmable Regulated Core Supply Voltage
● Supply Voltage Supervision, Monitoring, and Brownout
● System Operation From up to Two Auxiliary Power Supplies
● Unified Clock System
● FLL Control Loop for Frequency Stabilization
● Low-Power Low-Frequency Internal Clock Source (VLO)
● Low-Frequency Trimmed Internal Reference Source (REFO)
● 32-kHz Crystals (XT1)
● One 16-Bit Timer With Three Capture/Compare Registers
● Three 16-Bit Timers With Two Capture/Compare Registers Each
● Enhanced Universal Serial Communication Interfaces
● eUSCI_A0, eUSCI_A1, and eUSCI_A2: Enhanced UART Supports Auto-Baudrate Detection, IrDA Encoder and Decoder, Synchronous SPI
● eUSCI_B0: I2C With Multi-Slave Addressing, Synchronous SPI
● Password-Protected RTC With Crystal Offset Calibration and TemperatureCompensation
● Separate Voltage Supply for Backup Subsystem
● 32-kHz Low-Frequency Oscillator (XT1)
● Real-Time Clock
● Backup Memory (4 x 16 Bits)
● Three 24-Bit Sigma-Delta Analog-to-Digital (A/D) Converters With Differential PGA Inputs
● Integrated LCD Driver With Contrast Control for up to 320 Segments in 8-Mux Mode
● Hardware Multiplier Supports 32-Bit Operations
● 10-Bit 200-ksps A/D Converter
● Internal Reference
● Sample-and-Hold, Autoscan Feature
● Up to Six External Channels, Two Internal Channels, Including Temperature Sensor
● Three-Channel Internal DMA
● Serial Onboard Programming, No External Programming Voltage Needed
● Available in 100-Pin and 80-Pin LQFP Packages
Part 3D Model
