SN65LVDM176DGKG4 Datasheet PDF - TI

●The SN65LVDM176DGKG4 is a differential Line Driver and Receiver configured as a transceiver that uses low-voltage differential signaling to achieve signaling rates as high as 400Mbit/s. This circuit is similar to TIA/EIA-644 standard compliant devices (SN65LVDS) counterparts except that the output current of the drivers is doubled. This modification provides a minimum differential output voltage magnitude of 247mV into a 50R load and allows double-terminated lines and half-duplex operation. The receiver detects a voltage difference of less than 50mV with up to 1V of ground potential difference between a transmitter and receiver. The intended application of this device and signaling technique is for half-duplex or multiplex baseband data transmission over controlled impedance media of approximately 100R characteristic impedances. The transmission media may be printed-circuit board traces, backplanes or cables. The SN65LVDM176 is characterized for operation from \x9640 to 85°C.

● Low-voltage differential driver and receiver for half-duplex operation

● ESD Protection exceeds 15kV on bus pins

● Operates from a single 3.3V supply

● Propagation delay times

● LVTTL Levels are 5V tolerant

● Bus pins are high impedance when disabled or with VCC less than 1.5V

● Open-circuit fail-safe receiver

● Green product and no Sb/Br

●The ultimate rate and distance of data transfer is dependent upon the attenuation characteristics of the media, the noise coupling to the environment and other application specific characteristics.