SN65LVDM179DGKG4 Datasheet PDF - TI

●DESCRIPTION

●The SN65LVDM179, SN65LVDM180, SN65LVDM050, and SN65LVDM051 are differential line drivers and receivers that use low-voltage differential signaling (LVDS) to achieve high signaling rates. These circuits are similar to TIA/EIA-644 standard compliant devices (SN65LVDS) counterparts, except that the output current of the drivers is doubled. This modification provides a minimum differential output voltage magnitude of 247 mV across a 50-Ω load simulating two transmission lines in parallel. This allows having data buses with more than one driver or with two line termination resistors. The receivers detect a voltage difference of 50 mV with up to 1 V of ground potential difference between a transmitter and receiver.

●FEATURES

●• Low-Voltage Differential 50-Ω Line Drivers and Receivers

●• Typical Full-Duplex Signaling Rates of 100 Mbps (See Table 1)

●• Bus-Terminal ESD Exceeds 12 kV

●• Operates From a Single 3.3-V Supply

●• Low-Voltage Differential Signaling With Typical Output Voltages of 340 mV With a 50-Ω Load

●• Valid Output With as Little as 50-mV Input Voltage Difference

●• Propagation Delay Times

●   – Driver: 1.7 ns Typical

●   – Receiver: 3.7 ns Typical

●• Power Dissipation at 200 MHz

●   – Driver: 50 mW Typical

●   – Receiver: 60 mW Typical

●• LVTTL Input Levels Are 5-V Tolerant

●• Driver Is High Impedance When Disabled or With VCC < 1.5 V

●• Receiver Has Open-Circuit Failsafe