●The SN65LVDS1050 is similar to the SN65LVDS050 except that it is characterized for operation with a lower supply voltage range and packaged in the thin shrink outline package for portable battery-powered applications.
●The differential line drivers and receivers use low-voltage differential signaling (LVDS) to achieve signaling rates as high as 400 Mbps. The drivers provide a minimum differential output voltage magnitude of 247 mV into a 100- load and receipt of 100-mV signals with up to 1 V of ground potential difference between a transmitter and receiver.
●The intended application of this device and signaling technique is for point-to-point baseband data transmission over controlled impedance media of approximately 100- characteristic impedance. The transmission media may be printed-circuit board traces, backplanes, or cables. Note: The ultimate rate and distance of data transfer is dependent upon the attenuation characteristics of the media, the noise coupling to the environment and other application-specific characteristics.
●The SN65LVDS1050 is characterized for operation from 40°C to 85°C.
● Typically Meets or Exceeds ANSI TIA/EIA-644-1995 Standard
● Operates From a Single 2.4-V to 3.6-V Supply
● Signaling Rates up to 400 Mbit/s
● Bus-Terminal ESD Exceeds 12 kV
● Low-Voltage Differential Signaling With Typical Output Voltages of 285 mV and a 100 Load
● Propagation Delay Times
● Driver: 1.7 ns Typ
● Receiver: 3.7 ns Typ
● Driver: 25-mW Typical
● Receiver: 60-mW Typical
● Power Dissipation at 200 MHz
● Driver: 25 mW Typical
● Receiver: 60 mW Typical
● LVTTL Input Levels Are 5 V Tolerant
● Receiver Maintains High Input Impedance
● Receiver Has Open-Circuit Fail Safe
● Available in Thin Shink Outline Packaging With 20-mil Lead Pitch
Part 3D Model
