●[
●TEGAM
●]
●Automated Audio Test System Advantages
●TEGAM SG 5010 and AA 5001 programmable instruments in a computer controlled test system will make critical audio measurements consistently, accurately, and in two to four seconds each. Even complex tests can be made by non-technically-skilled operators since the procedures are controlled by software in the controller. And, permanent graphic or tabular records of test results can be produced at very low cost.
●Automated Audio Test System Advantages
●• Fast, Accurate, Repeatable Measurements.
●• Lower Required Operator Skill.
●• Automatic, Low-cost Documentation of Test Results in Graphic or Tabular Form.
●Instrument Performance Features
●• Extremely low residual noise and distortion permit measurements on top-grade professional and consumer audio equipment.
●• Performs all standard audio tests — THD, IMD (SMPTE, DIN, CCIF difference tone), gain/loss, signal to-noise ratio.
●• Analyzer input fully balanced, oscillator output balanced or unbalanced, floating or grounded, 50/150/600 Ω to match all types of audio equlpment.
●• Automatic swept measurements possible without IEEE-488 controller.
●• Four-or-more digit synthesized frequency, 0.01% guaranteed accurate.
●• Fully programmable filter and detector selection to meet a wide variety of measurement standards.
●• High level oscillator output to test head room, clipping thresholds of line level devices.
●• Ten non-volatile stored generator setups.
●• Generator includes burst, square wave, and amplifier modes.
